Tips for clearing pool water in 3 hours after a rainstorm

When the rain is over and you head to the pool with anticipation, what you see is a murky, yellow, muddy soup... Don't break down just yet! Mud, debris and bacterial contamination from heavy rains can be a real headache, but getting your pool water clear again in as little as 3 hours is not an impossible task. Master the following systematic approach and say goodbye to cloudiness!

 Golden 3 hours efficient water purification action guide：

1. POWER DISCONTINUITY SAFETY CHECK: First priority! Turn off the power to the pool pump and all related electrical equipment to ensure safe operation. Check for standing water, exposed wires or damaged equipment around the pool to eliminate potential hazards.

2. Large debris cleanup: Quickly salvage leaves, branches, plastic bags and other large debris floating in the water. Use a pool net (leaf net) to clean them carefully to avoid them clogging the subsequent filtration system.

3. Equipment Inspection and Preparation:

(1)Inspect and clean the pump basket and skimmer basket to remove clogs.

(2)Check the filter pressure gauge. If the pressure is too high (more than 25% above the cleaning pressure), backwash (sand/diatomaceous earth tank) or clean the filter cartridge (cartridge tank) immediately. This is critical to ensure subsequent filtration efficiency!

(3)Make sure that all valves are in the correct position (especially the main drain valve is closed).

4. Critical water quality tests and adjustments:

(1)Test Now: Using a reliable pool water test kit or paper, focus on pH and total alkalinity.

(2)Prioritize Total Alkalinity Adjustment: Storm water dilutes the water column, often resulting in a sudden drop in total alkalinity. Adjust it to the 80-120 ppm range.

(3)Accurate pH Adjustment: Accurately adjust the pH to the desired range of 7.2-7.6.

5. Thoroughly priming and draining:

(1)Switch the filter valve to WASTE mode.

(2)Move the suction head very slowly and smoothly (preferably using a manual suction head connected to a suction rod and hose), sucking only the flocculated sludge deposited on the bottom of the pool. Move slowly to avoid stirring up the sediment.

(3)Keep a close eye on the water level to avoid draining away too much water. Draining will rapidly deplete the pool water.

(4)Goal: Remove as much visible sediment from the bottom of the pool as possible.

6. Replenish clean water and resume circulation filtration:

(1)After draining, replenish with fresh tap water to normal level (usually in the middle of the sink wall or 1/2 to 2/3 of the skimmer opening).

(2)Switch filter valve back to FILTER mode.

(3)Turn on the pump for continuous filtration. There may still be a small amount of very fine suspended solids in the water, which will be further cleared by filtration.

7. Intensive disinfection and sanitization:

(1)Detection and Shock Disinfection: Stormwater brings in large amounts of bacteria and organic contaminants. Chlorine levels are checked and shock disinfection is usually required.

(2)Add enough chlorine to the calculated amount (based on current chlorine residual and water volume, refer to shock dosing instructions). Ensure that the agent is uniformly dissolved or splashed.

(3)Keep the pump running continuously to promote agent distribution and disinfection.